Why is my Chevy Impala not turning off?

This 2008 Chevrolet Impala came in with the complaint that the ignition switch would not turn all the way off. This resulted in not being able to remove the key (never try to force a key out) and several lights staying on and running the battery down. Testing starts with checking the RAP fuse.

Why is my Chevy Impala key stuck in the lock?

This prevents your Impala from “rolling off”. When the vehicle is in any other gear than park will act like neutral and roll away without the parking brake on. Leaving the key stuck in the lock is the manufacturers way of telling you that you need to put it in park before you leave the driver’s seat.

Where is the owner manual for a 2012 Chevy Impala?

Chevrolet Impala Owner Manual – 2012 Black plate (4,1) iv Introduction Using this Manual To quickly locate information about the vehicle, use the Index in the back of the manual. It is an alphabetical list of what is in the manual and the page number where it can be found. Danger, Warnings, and Cautions

What happens when the key is stuck in the ignition?

Car would not shift out of park. Once that wire was repaired, shifter will work fine, but cannot get the key out of the switch and the ignition will not go into the full off position. It’s stuck in acc mode and drains the battery.

Can’t Get key in ignition?

A common problem when your key is stuck in the ignition is that the car battery is dead or low on voltage . Charge your car battery for some time with a car battery charger to see if it’s a low voltage problem. Low voltage can cause the ignition lock not to release the key.

Why is my car stuck in ignition?

7 Reasons a Car Key Gets Stuck in the Ignition #1 – Parking Gear Not Set #2 – Steering Wheel Lock #3 – Debris on Key #4 – Dead Battery #5 – Worn or Damaged Key #6 – Damaged Ignition Cylinder #7 – Manufacturer Recall or TSB

What is an ignition lock cylinder?

Ignition Lock Cylinder. The ignition lock cylinder is a mechanical part where the ignition key is inserted to start a vehicle. It’s mounted inside the ignition switch, the electrical component that locks the ignition and “reads” anti-theft coding in the key to allow the vehicle to start. Worn keys can damage “wafer” tumblers or pins inside…

Where does the power to the ignition go?

Also doesn’t the ignition power run through the ignition Fuse in the 2nd row of the fuse block first or does it run through the ignition switch then down to the fuse block? The ignition switch is at the base of the steering column, on top, and has a huge plug with a number of 10 AWG wires going to it.

Why does my Chevy k1500 have no power?

I have a 1990 chevy k1500 and i blew up a batter then i lost dash power and my ignition wont engage anything and i have lights but no dash power or hvac controls Did you find the recommended reading relevant to this discussion?

Is there no power to the dash or ignition?

The problem I’m having with it is I have no power to the dashboard or ignition (turn key and nothing happens…no dash lights and no starter kick).

What happens when the car key is turned off?

When car key is turned off and check engine codes are cleared, the car starts up fine and continues to run smoothly. Luckily I was able to safely stop the car (albeit on the middle of a major highway), turn it off, clear the codes, and start it back up to get out of the way.

Where is the ignition lock solenoid on a car?

Using the same small screwdriver I lifted the manual button up on the bottom of the ignition lock solenoid assembly. It only takes a few ounces of pressure to lift the plunger button to the unlocked position so that the ignition can be turned off. I also removed the cover so that you can better see just what I am trying to accomplish.

What to do if your Chevy Impala key is stuck?

My 2007 Chevy Impala will not release my key… It will turn to position b but not to the off position to release the key. It will shift to all gear positions and drives but just won’t turn completely off to take the key out.

Why does my car key stay in the ignition?

MY PROBLEM IS THE SAME AS PREVIOUS COMPLAINTS: THE KEY WILL NOT DISENGAGE FROM THE IGNITION, THEREFORE IT STAYS IN THE VEHICLE ALL THE TIME. THE ONLY WAY I CAN CONTINUE TO DRIVE IS TO DISCONNECT THE BATTERY EVERY TIME I PARK AND LOCK THE CAR WITH MY SPARE KEY SO THAT IT WON’T GET RIPPED OFF.

Where is the shift lock solenoid on a Chevy Impala?

The shift lock solenoid is located under the center console, there are 5 wires and they break because using the shifting lever wears the wires in two. (like taking a piece of bailing wire and twisting it until it breaks).

Why are my interior lights not turning off?

When the door is open, the switch is closed and will allow current to pass. When the door is shut it presses the switch in and opens the circuit, which makes sense as to kill voltage to the interior lights. The headlight switch works fine.

Why do my park lights stay on after I Turn Off the motor?

My park lights stay on after I shut off motor and park. It drained my battery and while recharging I heard a noise in the under hood fuse panel. I pulled out the fuse that was vibrating and the light went out but after placing the fuse back in the park lights refused to go out. So now I can not park the truck without pulling the fuse.

Why do my head lights stay on when the car is shut off?

I forgot to mention that not only are my running lights on but my head lights also stay on when the vehicle is shut off. I pinpointed through a Chevrolet website that it is the BCM; body control module.

Why is my dome light not turning off?

Normal bulbs. The dome light white wire is negative switched. Remove the dome and do continuity from the white wire to ground, disconnect the driver side door switch and see if that opens the circuit. If not continue on with the footwells then to the headlight switch till you get an open circuit. Boost.

What to do if your headlight does not turn off?

Taking the entire dash off is a pain in the a$$ ( if you want to see all of the wires). Hope this helps. Well after replacing almost everything ( Keyless remote module,door jam switches,etc) the problem so far has been fixed by replacing the headlight dimmer switch with a brand new one, I was able to get one on ebay for only $40.00. So far so good.

Why does my headlight switch keep getting hot?

Click to expand… Sounds like you were on the right track with the headlight switch. Probably a circuit is shorted and its burning up the switch. I’d replace the h/s again and see if you can tell which ckt is getting hot. Not sure that helps, but around here finding the solution will always help others.

Can a key be removed from the ignition lock cylinder?

Ensure the transmission shift lever is in the PARK position and the steering column is NOT in the locked position. Verify the ignition key cannot be removed from the ignition lock cylinder.

What does it mean when the key won’t come out?

What I mean is you can change the gears without pushing the button on the side of the gear shifter so I didn’t know if this may be the problem since the key won’t cut off or come out if the car is not in park. My car has 999999 miles. My car has an automatic transmission. It is either the ignition switch electrical or the ignition lock cylinder.

What does it mean when your key is stuck in the ignition?

Key is stuck in the ignition and won’t turn all the way b… My key has been stuck in the ignition for a few weeks now and it’s still been cranking up until yesterday. Turn the key and nothing. From what I’ve read it could be the ignition switch gone bad but I just noticed also that the gear shift does not totally lock into park.

What are common reasons my Chevrolet Impala key wont turn?

What are common reasons my Chevrolet Impala key won’t turn? While there are a variety of reasons your Chevrolet Impala key won’t turn, the most common 3 are a binding steering column/lock, an ignition switch issue, or a problem with the ignition key. See what others are asking about their Chevrolet Impala.

How do you remove a key from a Chevy Impala?

Take all of the screws out and then move the shifter to the 1st gear position and remove a phillips head screw on the front of the shifter to remove the shift handle. Now lift out the console. You will more than likely see the broken wire when you look at the lower right side of the shifter close to the floor.

What happens when the ignition switch is off?

Generally speaking, in the “OFF” position, the ignition switch doesn’t connect anything; in the “ACC” position, the radio or fan may be energized; in the “RUN” position, the engine control module is energized; and finally, in the “START” position, the starter relay is engaged. (These generalizations, depend significantly on year, make, and model.)

How is the ignition switch connected to the car?

The ignition switch itself is connected to the ignition cylinder by a shaft or lever. Inside the ignition switch, several contacts connect vital electrical systems needed to start and run the car.

Why is my car not turning on when I Turn on the ignition?

Of course, if you access the car itself with your key, you likely won’t be able to turn on the ignition because of all those extra tumblers. And on the off chance that you do turn the ignition cylinder, the immobilizer won’t allow you to start the car, because it’s protected by one-in-millions of transponder codes.

When do you need a new ignition switch for a Chevy Impala?

Dash mounted. The easiest way to tell that you need a new ignition switch for Chevy Impala is if it requires several attempts for your sedan to start. If you need to turn the key multiple times until your car finally gets going, then the issue potentially lies with the switch.

Is there a problem with the ignition switch?

If you need to turn the key multiple times until your car finally gets going, then the issue potentially lies with the switch. Get your car checked out at AutoZone, where trustworthy advice is provided by a helpful staff.

Where can I get ignition switch checked out?

Get your car checked out at AutoZone, where trustworthy advice is provided by a helpful staff. To assist you further, AutoZone also offers a Loan-a-Tool program for DIY installation, as well as free battery charging and engine diagnostic testing.

How to fix Chevy Impala with security light on?

Chevy Impala No start? Security light on? FREE FIX with your finger! – YouTube Chevy Impala No start? Security light on? FREE FIX with your finger! If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.

How to fix Chevy Impala with your finger?

FREE FIX with your finger! – YouTube Chevy Impala No start? Security light on? FREE FIX with your finger! If playback doesn’t begin shortly, try restarting your device.

What are common reasons my Chevrolet Impala won’t start?

What are common reasons my Chevrolet Impala won’t start? While there are a variety of reasons your Chevrolet Impala won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.

What happens when the ignition switch fails in a car?

When the electrical portion of the ignition switch fails, the vehicle will permanently or intermittently lose power to certain systems and components, depending on which positio… Read More

What happens when the starter fails to start?

Starter motor failure produces one common symptom across all makes and models: When you turn the key, the starter solenoid will click, but the engine will not rotate. You also Read More When the computer senses the engine is out of time, it will turn on the check engine light. The engine may stall or even just fail to start.