Why is my bf ignition barrel not working?

Plugged it all in and bolted it back together but car still wont start. The key seems to function normally now, with the right clicks etc, but the car doesnt do anything at all when the key is turned. The ICC screen says Security code error. I was under the impression that I this wouldn’t happen if I used my original key, barrel and PATS board.

Can you use the ignition barrel from your car?

Can I use the barrel from my car and put it on the replacement steering rack to keep using the same key or doe these keys have some type of chip in them that will screw all this up. As you can probably tell I am pretty confused about this situation.

Why do I have the wrong key in my ignition?

Sometimes it’s a simple mistake, and the wrong key is inserted into the cylinder. This happens most often when someone has more than one car key on their key ring. Many keys look similar, especially if they are from the same make. So double check the correct key is being used to try to start the vehicle.

Can a worn ignition cylinder cause a car to fail?

A worn ignition cylinder may not function correctly when the key is inserted. This may lead to issues with certain positions of the key. Certain positions may not work correctly, or may require jostling of the key before they work. The issue will usually worsen until the unit eventually fails completely

Is there a problem with the ignition barrel?

I went out to start my car today and the key spins freely in the barrel and nothing happens. the car does not start. There seems to be a weak click between position I and II but nothing between II and III. I did a search and found some topics on BA having similar issues but in those topics the cars all started, where as mine nothing happens at all.

What to do if your ignition cylinder is out?

If your lock is retaining the key, or not moving with the proper key, it is best to call a locksmith. With the key turned to the proper position in the cylinder, all push pins depressed, and all fastening screws removed, the cylinder can be removed from the ignition. With the ignition cylinder out of the car]

What happens if you have an incorrect ignition code?

The chip in the key transmits a specific code, of which there are millions. If this code matches the ones programmed into the vehicle, engine starting is enabled. An incorrect key code, such as from an unprogrammed key or damaged key, would prevent engine starting. Code “confusion,” such as having multiple keys can also occur, preventing ignition.

How do you remove the ignition barrel on a Ford Falcon?

Below is the section from the workshop manual that describes depressing the pin in the side of the ignition lock barrel, it doesn’t mention a hole and wire. I do believe that method to be the case though on the earlier Falcons.