Where is the wiring harness on a headlight?

Wrap the end in painters tape if you fear the cable may accidentally become reconnected while you are working. Press inward on the side tabs of the headlight wiring harness on the rear of the headlight assembly. Pull the wiring harness off the rear of the headlight assembly.

How do you change the light pattern on a headlight?

Stick a piece of tape in line with the top of the light pattern from each headlight. Stick another piece of tape vertically in line with the center of the light pattern from each headlight. These strips of tape will provide a reference point for adjustments. Open the engine hood and look at the back of each headlight housing.

How do you remove negative battery from headlight?

Loosen the negative battery terminal nut with your crescent wrench. Lift the negative battery cable off the terminal nut and set it aside. Wrap the end in painters tape if you fear the cable may accidentally become reconnected while you are working. Press inward on the side tabs of the headlight wiring harness on the rear of the headlight assembly.

What to do if your headlight Cable gets reconnected?

Wrap the end in painters tape if you fear the cable may accidentally become reconnected while you are working. Press inward on the side tabs of the headlight wiring harness on the rear of the headlight assembly.

Where is the headlight screw on a Dodge Neon?

Turn the screw inside the hole clockwise to raise the headlight and counterclockwise to lower the headlight assembly. Locate the screw on the inside edge of the Dodge Neon’s headlight assembly.

Where is the lateral adjustment on a Dodge Neon?

Locate the screw on the inside edge of the Dodge Neon’s headlight assembly. Some models of the Neon do not offer a lateral adjustment. If your Neon offers a lateral adjustment, then you can turn the screw clockwise to move the headlight assembly to the left and counterclockwise to move the headlight assembly to the right.

Where are the adjustment screws on a neon?

On the Neon, there are two adjustment screws. One screw is located on the backside of the headlight housing assembly. The other screw, on some models of the Neon, is located on the inside edge of the headlight housing assembly. The screw on the backside of the headlight assembly controls the vertical adjustment of the headlight.

Where does the wiring go on a headlight?

The wiring harness connects to the base of the headlight bulb as well as the power distribution center in the engine compartment. No extraneous parts need to be removed to rewire the headlight, although the exact process varies by make and model of vehicle.