Where is the blend door actuator on a 2005 Ford Expedition?
The temperature blend door actuator is located on the right side of the transmission hump under the evap.
What controls a blend door actuator?
An air blend door actuator is a small electric motor that houses in a plastic construction. In the unit, a door position sensor is incorporated, too, that sends information to the climate control computer. This actuator hence controls the temperature and air direction as per the settings.
Where is the cabin filter on 2004 Ford Expedition?
Locate the cabin air filter container on your Ford Expedition. If you are standing in front of the vehicle, looking at the engine, it will be on the back, left side of the engine, next to the heater fan. You will see a black cover over the top of the container. The air filter is approximately 6″ x 9″ and about 2″ deep.
Does a 2004 expedition have a cabin filter?
Our research indicates that your vehicle does not have a cabin air filter (also known as a pollen or AC filter). This mesh is part of the vehicle and does not need to be changed. …
Can you replace the blend door on a Ford F-150?
This article applies to the Ford F-150 (2004-2014). The blend door mixes the hot air with the cold air in the cabin of your Ford truck. If the door is broken, sometimes only hot air will blow through the vents, or similarly, just cold air. Here’s how to replace the blend door yourself for under $200 and less than two hours of work.
What happens when you replace the actuator on a blend door?
Once all of the mounting screws have been removed the actuator should become loose. Grasp the actuator and pull it from its mount to remove. Before installing the new actuator it’s a good idea to manually turn the blend door in both directions to ensure it is not stuck which will cause the new actuator to fail.
How much does it cost to replace blend door?
If the door is broken, sometimes only hot air will blow through the vents, or similarly, just cold air. Here’s how to replace the blend door yourself for under $200 and less than two hours of work. The plastic post that is the actuator can bend or break, making movement impossible.
Can a heater be removed from a blend door?
If the door is stuck the heater plenum with need to be removed and the problem resolved before installing the new unit. To test the blend door operation and too double check that you are changing the correct actuator motor turn the blower motor on and work the door in each way. You will be able to feel the air change temperature or vent level.
How do you replace a blend door on a Ford truck?
While a dealer will remove the dash, evacuate the A/C and drain the heater, you can simply remove the glove box by squeezing the side in, releasing the tabs, and pulling down and out. Figure 1. Remove the glove box. Pull and pry the three squeeze-clips (or remove the 5/16 screws) to remove the actuator.
If the door is broken, sometimes only hot air will blow through the vents, or similarly, just cold air. Here’s how to replace the blend door yourself for under $200 and less than two hours of work. The plastic post that is the actuator can bend or break, making movement impossible.
How many degrees does a blend door need to move?
Check that the blend door moves using a 1/4” socket to manually move the door, which should have about 60 degrees of movement. If greater than 60 degrees, the axle is likely cracked. Once convinced the blend door is your problem, cut the plenum open at the bottom to remove the blend door.