Where can I get ignition switch replacement for Chevy Malibu?

Those looking to replace Malibu ignition switches may benefit from AutoZone’s free professional advice from employees in all locations. Same Day Store Pickup is perfect for those looking for parts in a hurry, or you can choose convenient home delivery.

How to replace a no start ignition switch?

GM Ignition switch replacement to fix a no start or intermittent start. Faulty ignition switch contacts can also cause the PassLock system to enable Click here to see step by step proceedures. http://www.thejunkmanadv.com/the-junk… Support the site, buy service manuals here : http://www.tkqlhce.com/click-7357719-… Loading…

What makes a Chevy Malibu a good car?

Your Chevrolet Malibu is the perfect solution to your transportation needs. Aside from style and a spacious interior, reliability is your ride’s top benefit. As your car eats up the miles, however, parts begin to age and deteriorate. One of these is the Chevrolet Malibu ignition switch, which leads to the impairment of your car’s ability to start.

Where is the fuse puller on a Chevy Malibu?

There is a fuse puller located on the instrument panel fuse block. It can be used to easily remove fuses from the fuse block. Before replacing a fuse check that the key has been removed from the ignition and that all the services are switched off and/or disengaged.

What are the signs of a failing a / C switch?

This switch is crucial for proper A/C performance. Signs of a failing A/C pressure switch include your A/C being unable to cool your cabin, the compressor not turning on, or your A/C system cycling on and off faster than normal. At O’Reilly Auto Parts, we have replacement switches, including A/C pressure switches, available for most models.

How long does it take to relearn GM ignition switch?

GM 10 minute relearn procedure Turn ON the ignition, with the engine OFF. Attempt to start the engine, then release the key to ON, the vehicle will not start. Observe the SECURITY light. After approximately 10 minutes, the security light will turn OFF.

Where is the Hall affect sensor on a GM ignition switch?

Passlock Operation. This Passlock sensor is located inside the ignition switch and receives a reference voltage (5 volts) from the Body Control Module when turning the key on. This means that the sensor inside the ignition switch is considered to be a hall affect sensor.

What should I do if I need to replace my ignition switch?

Reconnect the cable to the negative (-) terminal on the battery, then insert the key into the ignition and turn it to start the vehicle. The vehicle should start without any issue. If it doesn’t, remove the ignition switch and reinstall it. Shut the engine off (if it starts) and disconnect the battery again.

What to do if your key is stuck in the ignition switch?

The key may be stuck in the ignition switch, but that shouldn’t stop you from turning it. If you don’t have a key, you will need to force the module to turn using a flathead screwdriver. Press the release pin inside the hole on the ignition module with a screwdriver.

Why do ignition switches need to be good?

This rather important component transmits the signal from the key to the ignition system that allows your car to run, and over time, build-up of grime and grit interrupts this contact, preventing the proper start-up process from completing.

How to troubleshoot a temperature gauge in a car?

Temperature gauge troubleshooting begins with isolating the problem either to the gauge, sending unit, fuse or wiring. As with any electrical troubleshooting it is best to check all wiring connections are clean, tight and free of corrosion. The following process must be preformed with the ignition key turned to the “on” position.