What to do when cylinder head is removed from Mazda 6?
The cylinder head and the camshaft caps are numbered to make sure they are reassembled in their original position. When removed, keep the caps with the cylinder head they were removed from. Do not mix the caps. Loosen the camshaft cap bolts in several passes in the order shown. Loosen the cylinder head bolts in several passes in the order shown.
What to do with a Mazda 6 engine?
1. Remove the timing chain. (See TIMING CHAIN REMOVAL/INSTALLATION.) 2. Remove the ignition coil. (See IGNITION COIL REMOVAL/INSTALLATION.) 3. Remove the high-tension lead. (See HIGH-TENSION LEAD REMOVAL/INSTALLATION.) 4. Disconnect the generator, but do not remove it from the vehicle.
How do you adjust the headlights on a Mazda 6?
Back the Mazda 6 up 25 feet and turn on the headlights. Determine what needs adjusting by seeing where each beam hits the wall. Both headlights should hit two inches below the horizontal strip of tape. The passenger’s side should also hit directly on the vertical strip (in front of it).
How to tighten engine bracket on Mazda 6?
1. Tighten the No.3 engine mount bracket stud bolt. 2. Tighten the No.3 engine joint bracket bolt and nut in the order shown. 1. Tighten the No.4 engine mount bracket and No.4 engine mount rubber bolt and nut in the order as shown.
The cylinder head and the camshaft caps are numbered to make sure they are reassembled in their original position. When removed, keep the caps with the cylinder head they were removed from. Do not mix the caps. Loosen the camshaft cap bolts in several passes in the order shown. Loosen the cylinder head bolts in several passes in the order shown.
What should I do to my Mazda 6?
TIMING CHAIN REMOVAL/INSTALLATION Warning Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel line spill FRONT OIL SEAL REPLACEMENT 1. Disconnect the negative battery cable. 2. Remove the spark plugs.
Can I-car Send Me Mazda repair procedures?
Can I-CAR send me Mazda repair procedures? Is there a sectioning procedure available for the B-pillar reinforcement? Is there a sectioning procedure available for the front lower rail?
How to install a cylinder gasket on a Mazda 6?
1. Set the cam position of the No.1 cylinder at the top dead center (TDC) and install the camshaft. 2. Temporarily tighten the camshaft bearing caps in two or three even movements. 3. Tighten the camshaft cap bolts in the order shown using the following two steps. TIMING CHAIN REMOVAL/INSTALLATION Warning Fuel vapor is hazardous.