What should I do when I change my wheel bearings?

The worst thing that can happen when changing your wheel bearings is for your vehicle to suddenly shift or roll away. Before you begin, park your vehicle on a level surface. Put the vehicle in park (or, for manuals, 1st, reverse, or neutral) and be sure to put the parking brake up. Note: Every vehicle is different.

Can a wheel bearing be changed without a cassette?

Remove the freewheel or cassette, if required. It is generally possible to change wheel bearings in the rear hub without removing the freewheel, but it may be more difficult. If you have a cassette, you will have to remove it.

Where does a wheel bearing go in a car?

In many cars a wheel bearing comes together with a hub as an assembly. Tapered roller bearings like this one come in pairs, one larger bearing, one smaller bearing. It bolts to the steering knuckle or spindle.

How do you change a front wheel axle?

Remove the knuckle assembly from the car and prepare it for the press. Step 6. Set the knuckle assemble on the press and suspend it safely, remove the center hub, starting from the back of the bearing, and only press out the center of the bearing. Step 7. Flip it over and remove the snap ring or retaining ring from the knuckle assembly.

When does a wheel bearing need to be replaced?

Most wheel bearings are sealed at the factory and don’t typically require replacement until around 150,000 miles or 240,000 kilometers, but there are some cars on the road whose wheel bearings do require regular service.

How much does it cost to replace a wheel bearing?

How Much Does Wheel Bearing Replacement Cost ? March 24, 2020 / 0 Comments / in Car Repair , Wheel Bearing / by Bridwell On average, wheel bearing replacement costs about $441 in the US for 2020, wheel bearing replacement costs can range from $383 to $498 according to RepairPal.com , and other sources.

How do you change wheel bearings?

To change wheel bearings, start by lifting the wheel up on a jack, unscrewing the lug nuts, and taking the wheel off. Then, remove the brake caliper, the dust cover over the rotor, and the cotter pin and castle nut behind the dust cover.

How do you install a wheel bearing?

How to install a wheel bearing race. Wheel bearing race & Seal Driver ( Matco BRS10) Make sure you replace the wheel bearing races before you resurface the rotor. Lay the rotor on a piece of wood. Using your chisel, chisel out the race by hitting the lip of it. Flip over the rotor and set the new race in place.