What should I do if I have an automatic gearbox problem?
1 the connector on the top remains with the unit and drops with the unit when it is removed. 2. package well in plastic and bubble wrap. don’t attempt to clean, or remove any parts to have a look. 3. There is no need to remove the wheel, or arch liner as suggested by some.
What’s the problem with the B class gearbox?
That the gearbox ecu is actually inside the gearbox and they along with the B class suffer from the speed sensor on the main ecu board failing. Anyhow, I found a gearbox rebuild specialist down my way south east England who plugged it into a merc fault reader and pulled up speed sensor errors and downshift errors.
What is the fault code on a Merc A160?
Our Merc A160 gives the following fault code: 2530 “The hydraulic pressure in component Y37y1 (Pulse width modulated solenoid valve 1/4 shift) and (or) at regulating valve 2/5R is too high or at regul… read more MB Paul Mercedes Technician Vocational, Technical or Trade Scho
What to do if your transmission is stuck in gear?
If your transmission is stuck in gear and you are far away from home, try this: 1 Pull over and turn the car off. Remove the key. 2 Do not press the gas pedal or any other buttons on the car. 3 Wait 20 seconds. 4 Start the car and drive to see if it is out of limp mode.
1 the connector on the top remains with the unit and drops with the unit when it is removed. 2. package well in plastic and bubble wrap. don’t attempt to clean, or remove any parts to have a look. 3. There is no need to remove the wheel, or arch liner as suggested by some.
That the gearbox ecu is actually inside the gearbox and they along with the B class suffer from the speed sensor on the main ecu board failing. Anyhow, I found a gearbox rebuild specialist down my way south east England who plugged it into a merc fault reader and pulled up speed sensor errors and downshift errors.
What can cause an automatic transmission to not work?
Yet it can get even worse, since it could be electric component failure. Of all automatic transmission problems, this may not allow the Electronic circuits to control the transmission. You will a vehicle which cannot work properly. Sadly, your vehicle must be fixed this issue as soon as possible.
Our Merc A160 gives the following fault code: 2530 “The hydraulic pressure in component Y37y1 (Pulse width modulated solenoid valve 1/4 shift) and (or) at regulating valve 2/5R is too high or at regul… read more MB Paul Mercedes Technician Vocational, Technical or Trade Scho
Can a bad ignition switch cause a car not to start?
However, if your car has ignition switch problems, you may not be able to start the car at all. Ignition switch problems can also cause issues on the road, such as unexpected shutdowns or electrical problems.
Yet it can get even worse, since it could be electric component failure. Of all automatic transmission problems, this may not allow the Electronic circuits to control the transmission. You will a vehicle which cannot work properly. Sadly, your vehicle must be fixed this issue as soon as possible.
What causes a car ignition switch to jam?
Step 9 – Most vehicles with an automatic transmission utilize an interlock cable that prevents the transmission to be moved from the park position. If the gear shift selector is not completely in park it can cause the ignition switch to jam due to interlock misalignment.
Is there a way to unlock the gearbox?
There is also an option to unlock Gearbox Selector keyless. You need to remove the cover surrounding Gerbox selector. And then, you will see a yellow ( clearly marker leaver ), push it down and HOLD and move the gerbox selector to neutral (N) position.