What is IGN C fuse?

That means there is a short to ground between the wire from the fuse box to the ignition switch. It comes out of the ignition switch as a red wire it comes out of the fuse box as a orange wire ad they meet in the middle with a splice.

What are the fuses on a 2002 Avalanche?

Make and Model > Chevrolet > Avalanche > 2002 Chevrolet Avalanche… IGN A Fuse #3 40A Starter Relay, Ignition Switch IGN 1. TURN. SEO IGN Fuses PARK LP Fuse #12 30A Park Lamp Relay. Healamp and Panel Dimmer Switch Park Lamps STOP LPS Fuse #14 20A VEH STOP and CHMSL Fuses. Trailer Wiring (LH.

Why is the crank fuse at the start position?

Could be the ignition switch faulty try a hot wire direct to the starter motor small terminal then see if it cranks You can’t post conmments that contain an email address.

What are the fuses on a Chevy Silverado?

STOP LPS Fuse #14 20A VEH STOP and CHMSL Fuses. Trailer Wiring (LH. RH Turn and Stop Lamp) ECM 1 Fuse #15 10A Vehicle Control Module (VCM)/Powertrain Control Module (PCM) from IGN I Relay) INJA Fuse @20 15A Fuel injectors 1. 3, 5, and 7. Ignition Coils. Glow Pug Module, Fuel Heat.

Where is the auxiliary cooling fan fuse block?

The auxiliary electric cooling fan fuse block is located in the engine compartment on the driver’s side of the vehicle next to the underhood fusebox. *5 — PCM Ignition.

When does the crank fuse only have power?

The CRANK fuse will only have power when the engine is cranking (start portion of ignition switch). Power flows through the ignition switch in the start position, through the neutral switch (manual)to the starter and crank fuse then to the ECM from the crank fuse.

The auxiliary electric cooling fan fuse block is located in the engine compartment on the driver’s side of the vehicle next to the underhood fusebox. *5 — PCM Ignition.

What does the crank fuse do on a S-10?

It is actually the ECM that sends a signal to the ICM for it to take over timing control, this is a 5V signal applied to bypass wire to allow the ESC signal to become active. Some MS users have played with having the 5V signal active as soon as the key is turned on, to be able to adjust spark timing during cranking, with some success.