What are the components of a distributor ignition system?
The following are common ignition system components:
- Battery.
- Distributor Cap and Rotor.
- Ignition Coil/ Coil Packs/Coil- On-Plug (COP)
- Spark Plug Wires.
- Spark Plugs.
- Ignition Module.
- Powertrain Control Module (PCM)
- Crankshaft and Camshaft Sensors.
How does an electronic ignition module work?
An electronic ignition system is a type of ignition system that works electronic circuits, usually by transistors. The transistors are controlled by sensors to generate electric pulses which then generate a high voltage spark that can burn the lean mixture and provide a better economy and lower emission.
How to troubleshoot the ignition system in a Mitsubishi Eclipse?
Secure the Eclipse by putting the gear shift in “Park” and applying the emergency brake. Perform the cylinder drop test with the engine idling. Remove a spark plug with insulated pliers for a few seconds. Inspect the plug and wire if the removal doesn’t cause a drop in engine performance.
How does the ignition work on a Mitsubishi 3.0L V6?
Here’s a little working theory of how the ignition system on your Mitsubishi 3.0L V6 creates the spark needed to get your vehicle started and running. In a nutshell, when the ignition system is working properly and you turn the key to crank and start the engine:
Is the Mitsubishi ignition system the same as Dodge?
To make sure this test tutorial applies to your specific Mitsubishi or Dodge vehicle, please take a look at the application chart at the bottom of this page (mobile device) or on the left column of this page (PC). Contents of this tutorial: Ignition System Basic Working Theory.
How do you check ignition resistance on Eclipse?
Probe the terminals at the distributor for other engines. Measure the resistance between the secondary ignition coil terminal on the distributor cap and terminal 1 or 2 of the distributor connector. Compare the measured resistance to the required specifications for your Eclipse’s engine (refer to the Tips for the list).