How to programming the keys on a Land Rover?
2 Put one of the keys in the ignition and turn it to the first click and then back off within five seconds to put the car into initialization mode. From this point, you must continue key programming within 30 seconds or the system times out . . .
How to program the pushbutton on a Land Rover?
The pushbutton keys in Discovery II models can only be coded by a shop with the Autologic, T4, or IDS diagnostic systems. The pushbutton keys in these models can only be coded by a shop with the Autologic, T4, or IDS diagnostic systems. John Elder Robison is the founder of J E Robison Service, independent Land Rover specialists in Springfield, MA.
Is there a way to program a range rover Remote?
Unfortunately it will probably have to be taken to your local dealer with your Range Rover to have it programmed, there is a way to program just the remote if it was to loose sync with the alarm system.
How do you lock and unlock a Land Rover?
Turn it to lock while pressing the lock pushbutton. Hold for 5 seconds. Turn to unlock, press unlock and hold 5 seconds. At that point, the vehicle should lock and unlock via pushbutton.
2 Put one of the keys in the ignition and turn it to the first click and then back off within five seconds to put the car into initialization mode. From this point, you must continue key programming within 30 seconds or the system times out . . .
The pushbutton keys in Discovery II models can only be coded by a shop with the Autologic, T4, or IDS diagnostic systems. The pushbutton keys in these models can only be coded by a shop with the Autologic, T4, or IDS diagnostic systems. John Elder Robison is the founder of J E Robison Service, independent Land Rover specialists in Springfield, MA.
Unfortunately it will probably have to be taken to your local dealer with your Range Rover to have it programmed, there is a way to program just the remote if it was to loose sync with the alarm system.
Where is the transponder chip on a Land Rover?
Take the transponder chip (tiny black lump, maybe 8mm long.) out of your working key and glue it to the ignition barrel underneath the plastic steering column shroud.