How to measure suspension level control control calibration?

Wait until the car goes into 2 different levels. Measure the heights from wheel center to the lower edge of the fender (see comments ). Enter the ACTUAL MEASURED VALUE FROM THE CAR in “new value” in Millimeters into Channel 01. Measure the heights from wheel center to the lower edge of the fender (see comments ).

How is the ride height of a car measured?

Further research shows the CM-09606 measures “the vehicle level (ride height) is gauged using the position of the transverse link on the front axle and the drive shaft on the rear axle as reference points”, so I guess I could take a few measurements with an angle gauge and see what I get.

How to set the Mazda power liftgate height?

Turn on your CX-5 or CX-9 and put the gear shift into “Park” Use the liftgate interior button, key fob button, or button on the vehicle liftgate to open the trunk fully Once open, pull down the vehicle’s liftgate to the desired height you want it to open to Press and hold the liftgate button located on the liftgate until you hear two beeps

How does rear height adjust on Range Rover Sport?

The convenient Rear Height Adjust feature on the Range Rover Sport lowers boot entry up to 50mm for a more comfortable way to load and or unload your belongings. More than six decades ago, Land Rover marked its first trails on the sands of Arabia. And felt right at home amidst the adventurers and visionaries, terrains and landscapes.

How tall can discovery go out of calibration?

I have read from a d3 owner that some times the discovery height can go out of calibration for upto 8cm. I might be worrying but I do think other d3’s sit higher in normal ride height than mine, although not found one i can park next to and check.

How to calibrate your reverse parking sensors to your needs?

Now that it is hooked up, you can control your settings and calibrate it to your own needs, including how much space you would like before it beeps. After that, you should test out your sensors and make sure that everything is hooked up correctly and functioning properly.

How tall is the suspension on a 2006 disco3?

Right, I’ve just measured from the floor to the underside of the middle of the wheel arch – and its 32″. But, I’ve not moved the car since dropping it from offroad height to standard height, so could be sitting a bit higher than normal! 2006 disco3 SE.