How much does it cost to replace a CV boot?
The average cost for CV boot replacement is between $322 and $366. Labor costs are estimated between $171 and $216 while parts are priced at $151. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.
How much does it cost to replace a CV joint?
The costs for a double axle joint replacement are, as you might expect, around twice the cost of a single. Costs can range from $149 to $399 for parts, while parts and labor will range from $235 to $1178 depending on the amount of work involved. Replacement CV Joint Cost Comparison
Are there any aftermarket CV joint boot kits?
Aftermarket’s Rear CV Joint Boot focuses on rear-wheel-drive VW vans from 1968-1992, and Vemo’s Inner CV Joint Boot Kit focuses on front-wheel-drive VW vans through 2003. Vaico CV boot kits provide good coverage for Mercedes models from 1986-on along with later BMWs, VWs, and Audis.
How do you install a new CV boot?
The new CV Boot is installed by packing the joint with CV grease, reassembling the axle, and connecting the new boot. The CV Boot is tested for operation and the axle is reinstalled onto the vehicle.
The average cost for CV boot replacement is between $322 and $366. Labor costs are estimated between $171 and $216 while parts are priced at $151. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.
Do you need a CV joint boot kit?
This CV joint boot kit contains the parts required to repair the CV joint on specified vehicles without removing the joint itself. Made of quality components, this kit is engineered for reliable performance and durability.
The costs for a double axle joint replacement are, as you might expect, around twice the cost of a single. Costs can range from $149 to $399 for parts, while parts and labor will range from $235 to $1178 depending on the amount of work involved. Replacement CV Joint Cost Comparison
How are the two CV joints on a drive axle replaced?
The two CV joints on a drive axle can be replaced separately. That involves removing the axle, removing the axle boot and then the joint, installing a new joint, new grease and the boot, then, reinstalling the axle in the vehicle. This is almost never done.
Replacing a CV joint will most probably cost the same as replacing the axle shaft, but the overall cost will depend on whether or not you’re replacing one or both components. You can buy a new axle shaft for 86 to $200, whereas parts and labor combined can cost anything from $150 to $750.
What do you need to know about CV joint boots?
Inspect the CV Joint Boots. When you are in a position to see one or both CV axles, look closely at the CV boots located at each end of the axle. (Each axle has two CV boots). Visually inspect each rubber boot for cracks and tears.
When do you need to replace a CV axle?
PRO TIP – If a CV boot tears on an axle that has more than 100,000 miles on it, it’s usually most economical in the long run to bear the cost to just replace the whole CV axle. Joints can also wear out if the boot is intact.
If you notice serious trouble with it, you should replace it entirely as soon as possible before it disintegrates. Mechanics and auto repair shops charge around $190 to $3,000 for each CV joint replacement, depending on the model of your car.
Where to look for CV joint boots on a car?
Or, when there is less room underneath the vehicle to maneuver, slide underneath one side of the vehicle immediately in front of or behind the front wheel to inspect one axle at a time. Inspect the CV Joint Boots. When you are in a position to see one or both CV axles, look closely at the CV boots located at each end of the axle.
Can a CV axle be replaced by a repair shop?
In some cases a repair shop will simply replace the CV boot, but typically the entire CV axle will be replaced with a new or remanufactured axle, because the costs are about the same and the shop might not be willing to guarantee the work unless the entire axle is replaced.