How does my airbag module reset and return work?

MyAirbags is committed to helping you reset your airbag module and seat belts. We provide a reset and return service to reset airbag control modules. This service requires you to remove and send your module to us for reset. When we receive your airbag module, we reset ALL fault codes.

How can I reset the airbag light on my car?

Repeat the first few steps two more times and you will see that you have reset the airbag light on the dash. You will know that it is reset once the light comes on and turns off. It will not flash. And that’s how you reset an airbag light. If only all your DIY projects could be this easy.

Where do airbags go after they are repaired?

The repaired module MUST GO BACK INTO THE SAME VEHICLE FROM WHICH IT WAS TAKEN. Airbag modules are matched to a specific car, like an address. Each airbag module is matched with all or part of the vehicle’s VIN.

Where are the fault codes stored in an airbag module?

Even after small accidents, fault codes will be stored in the module which will turn on the airbag light. We reset and clear all crash codes inside the computer module which will turn off the airbag light.

What’s the problem with my 2008 Impala service air bag?

Same thing with my 2008 impala. The “service airbag” would turn on and off randomly. Now it’s been on for a while. I’m taking it to the dealership on Friday to see what the problem is. Also I have the same issue with the powerlock on the driver side.

How to reset the airbag light on Chevy Impala?

You can’t post conmments that contain an email address. Try under the dash, attached to colum is a switch that the rod goes into from your ignition key switch, that may need to be adjusted tword your steering wheel just a touch, they go out of alignmnet from time to time You can’t post conmments that contain an email address.

How to reset HVAC door in 2008 Impala?

2008 Impala base 3.5 model was not blowing any heat out of my defogger vent and floor vent, only out of upper dash vents, regardless of setting. With the key in the off position, I pulled the 10 amp DISPLAY fuse as noted above from the fuse panel under the hood and waited about 2 minutes.

Is there a way to reset the airbag light?

The airbag light will often go away by itself after repairing the problem, but not in all car models. After you have installed the new parts and are 100% sure that the parts are installed correctly, it’s time to reset the engine light. To do this – you need to use an OBD2 scanner, and it’s not possible in another way.