How do you turn the airbag off in a Mercedes?

You can disable the passenger airbag by disconnecting the connector to the airbag & inserting a 3Ω resistor between the 2 contacts to fool the SRS control module into thinking the airbag is still plugged in.

What happens if you remove the airbag fuse?

The fuse will not activate the airbags. The NHTSA says that you can’t remove or disable the airbags on any registered, road-driven vehicle newer than 1996 without a waiver. … Simply pulling the airbag fuse may not disable the airbags. Many ACMs utilize an internal battery to ensure deployment even if the power is cut.

Is the front passenger airbag disabled in Mercedes?

Mercedes Front Passenger Airbag Disabled Enabled See Oper. Manual Mercedes-Benz vehicles including E, C, S, CLS, ML, GL, R, G Class, may display a warning message stating front right SRS has malfunctioned and needs to be repaired. Front Passenger Airbag Disabled See Oper.

Is there a way to turn off the passenger side airbag?

Yes there is a passenger seat sensor that uses occupant’s weight to turn off the passenger side airbag. This is part of the SRS system on my 2001 W163.

What happens if you put child seat in front of airbag?

There is a penalty for drivers who place a rearward-facing child car seat in the front where there is an active airbag. You may receive at least three penalty points on your driving licence if caught. Remember to re-activate the airbag whenever the seat is going to be occupied by a passenger.

How to set zero point on Mercedes airbag?

Here are the general steps and some important tips to keep in mind when calibrating the passenger weight sensor on Mercedes-Benz cars. When asked to move the seat FORWARD and UP. Do so but once the seat gets all the way to the front, bring it back 3 to 4 inches and down about one inch. This will set the ZERO POINT SETTING.

Yes there is a passenger seat sensor that uses occupant’s weight to turn off the passenger side airbag. This is part of the SRS system on my 2001 W163.

Can a Mercedes airbag be reset by myairbags?

The best part of having your Mercedes original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play. No additional programming of the VIN is required.

What are the fault codes for Mercedes airbags?

Call us at 888-779-9029 M-F 9-5 EST Review the table below for information on Mercedes airbag fault codes: The cause is the cable routing under the passenger seat. The wire was dressed from the factory such that the cabling to the connector was under tension.