How do you reset the change oil light on a 2000 Chevy Impala?

With the engine off, turn the ignition key to ON. Fully press and release the accelerator pedal three times within five seconds. (If the CHANGE ENGINE OIL message flashes, the system is reset.)

How do you reset the change oil light on a Chevy Impala?

Start with the ignition completely off, then turn the ignition to the “ON” position. Do not start the engine. Slowly press the accelerator pedal all the way down 3 times within a 5 second interval. The “Change Engine Oil” message should flash 3 times and clear.

How do you reset the oil light on a 2002 Chevy Impala?

Turn the ignition to ON, with the engine off. Fully press and release the accelerator pedal slowly three times within five seconds. If the CHANGE ENGINE OIL message flashes, the system is reset.

How do you reset the oil light on a 2007 Chevy Impala?

2007 to 2011

1. Insert the key into the ignition.
2. Turn the key to the on position, but do not start it.
3. Press the fuel information button until you see “Engine Oil Life” in the display.
4. Press and hold the “Set/Reset” button.
5. Observe as the engine oil life returns to 100.
6. Turn the key to the off position.

How do you reset the change oil light on a 2004 Chevy Impala?

With the key in the ignition, turn the vehicle to the on position without starting the vehicle. Then You need to press and release the gas pedal three times within 5 seconds. The oil change light will flash twice and then just turn the vehicle off and then on.

How to reset engine oil light on Chevy Impala?

Reset the “Change Engine Oil” message on your Chevy Impala with these steps. Start with the ignition completely off, then turn the ignition to the “ ON ” position. Do not start the engine. Slowly press the accelerator pedal all the way down 3 times within a 5 second interval.

How do I reset the change engine oil light?

The “ Change Engine Oil ” message should flash 3 times and clear. To remove the “CHANGE ENGINE OIL SOON” message and reset your oil life, look to the right of the steering wheel. Here you’ll find four buttons to interact with the display (aka the driver information center).

When to reset the oil life monitor reset?

If the CHANGE ENGINE OIL light comes back on and stays on, oil life monitor has not reset. Repeat reset procedure. The CHANGE ENGINE OIL message is displayed when its time to change engine oil, usually between 3000 and 7500 miles since last oil change.

Reset the “Change Engine Oil” message on your Chevy Impala with these steps. Start with the ignition completely off, then turn the ignition to the “ ON ” position. Do not start the engine. Slowly press the accelerator pedal all the way down 3 times within a 5 second interval.

The “ Change Engine Oil ” message should flash 3 times and clear. To remove the “CHANGE ENGINE OIL SOON” message and reset your oil life, look to the right of the steering wheel. Here you’ll find four buttons to interact with the display (aka the driver information center).

How do I reset the engine oil life monitor?

To reset the engine oil life monitor using the accelerator pedal, go to step 5. To reset the engine oil life monitor using the radio, turn the radio off. Turn ignition to ACC or ON, with the engine off. Press and hold the DISP button on the radio for at least 5 seconds until SETTINGS is displayed.