How do you put transmission fluid in a Suburban?

To fill the fluid you should use a funnel and pour it into the hole where you pulled the dipstick. After filling, replace the dipstick, and after a few moments remove to confirm that it has been done correctly.

How do you add fluid to a transmission?

1. Place the funnel in the transmission check tube. The funnel will take the place of the dipstick. 2. Add the fluid in very small increments. It is important to add only a little bit at a time. You need to be careful about how much you are adding because you actually do not need that much.

How do you check your automatic transmission fluid?

Steps Park your car on a level surface with the engine running. Raise the hood. Find the automatic transmission fluid pipe. Pull out the transmission fluid dipstick. Check the condition of the transmission fluid. Add transmission fluid, if necessary. Run the car and take it through each gear if possible.

How many quarts of transmission fluid do you need?

If you’ve drained the fluid from the pan, removed the pan and replaced the filter, you may need to add anywhere from 4 to 12 quarts, depending on the make and model. Finished. Your car’s transmission fluid is now properly set and your car should be humming along.

Where do you put the dip stick in a transmission?

The fluid needs to at least be between these two lines. If it is below the bottom line, then more fluid needs to be added. Between the add and full line on most small to mid size vehicle transmission dip sticks will equal about a pint of fluid. Before adding any fluid, take a moment to inspect what the actual fluid looks like.

Where do you put the fluid in the transmission?

Check the fluid level on the dipstick. The fluid should be between the hash marks on the dipstick. If it is below the lower hash mark, you will need to add more fluid. Next, it is time to add more fluid. First, make sure you check your owner’s manual to make sure you have the correct fluid for your specific vehicle and transmission.

What do I need to fill my transmission?

What you will need to check or fill your transmission is a clean rag or paper towel, a long funnel, and your car’s specific transmission fluid. Every vehicle is different — check your owner’s manual to see what type of fluid your car needs. You must check your fluid levels while the car is warmed up to operating temperature.

How much transmission fluid should I add at a time?

If you notice the transmission fluid is a little low on the dipstick, start with a half a quart to a quart of transmission fluid. Recheck the level and add ¼ quart (or less) at a time until the level is up to the full or max mark. Are you doing a transmission service where you drop the pan and replace the filter?

How can I get an accurate transmission fluid reading?

Start your car. In order to get an accurate transmission fluid reading, you will need to check the level while your transmission is running and the fluid is warm. Keep your car in park with the handbrake on while you check the transmission fluid.