How do you adjust spring tension on V brakes?
V-brakes have a small screw at the bottom of each brake arm. These adjust the spring tension. To move the brake pad away from the rim, increase the spring tension by screwing inwards. To move it towards the rim, decrease the spring tension by unscrewing.
Do you need Rattle Springs on brake pads?
You only need the one shim set on brake pads. However there are often anti rattle springs on the left and right sides of the pads similar to the picture above and if your original pad set had such shims they must be removed and carefully cleaned and re used.
How to install the anti rattle clip on brake pads?
If you lack the tools or confidence to perform the job properly, have the work done by a qualified motorcycle technician. Check and double check that the anti-rattle clip is properly installed and secure before riding your motorcycle.
What should I do when I Change my brake pads?
When changing brake pads you need to take care that you re use or replace the essential hardware that was on the original pads when the car was built. Hardware on original pads often includes stainless steel silver shims on the reverse of the pads and these CAN be re used IF THE NEW SET OF PADS YOU HAVE do not have any shims.
Why does my car make a rattling noise when I brake?
Other possibilities could be missing or broken brake pad anti-rattle clips, or using inexpensive brake pads. The anti-rattle clips keep the pad from rattling when not braking. Inexpensive brake pads may not fit and could be loose, also causing them to rattle.
If you lack the tools or confidence to perform the job properly, have the work done by a qualified motorcycle technician. Check and double check that the anti-rattle clip is properly installed and secure before riding your motorcycle.
How to avoid using disc brake retainer Springs?
To avoid this, cancel and sign in to YouTube on your computer. This Channel will be based on learning how to do things, as I do them, so that means all my mistakes are captured for you to avoid.
How are the brake pads attached to the spindle?
The caliper mounting bracket is bolted to the spindle, and holds the brake pads in position relative to the brake rotor. The caliper fits over the pads and is fastened to the brackets with special sliding bolts. These bolts usually have dust boots.
What’s the best way to remove a brake caliper?
Inspect the inside of the caliper and remove the brake pads. Remove the two remaining bolts that hold the caliper bracket to the knuckle. Use a wire brush to clean rust from the rails where the pads contact the caliper. STEP 7: With the caliper out of the way, remove the rotor.