What was the problem with my 1999 Tahoe?

THE PROBLEM WITH MY TAHOE WAS ACCUALY PRETTY SIMPLE THE LAST TIME WE CHANGED THE FUEL PUMP I WAS TESTING FOR POWER AT THE MAIN PLUG FOR PUMP ASSY.

Why does my Chevy Tahoe stall while driving?

Bad fuel or fuel starvation could cause some stalling too! I had a car once that developed a small hole in a rubber fuel line causing the car to **** air and stall. Check you fuel lines especially if they are rubber.

Can a Chevy Tahoe shut off while driving?

When driving tahoe the engine shuts off sometimes can restart, but now it took 24 hrs before restarting chevy garage check codes nothing Clicking this will make more experts see the question and we will remind you when it gets answered.

What kind of ignition switch does Chevy Tahoe have?

My abs light keeps turning on and off and sometimes when I’m stopping the break will pulsate under five miles an hr its a 2003 chevy tahoe. 98 chevy ignition switch…

Is there a problem with my Chevy Tahoe?

I’ve been having a problem lately with my 4DR 4WD Chevy Tahoe. Lately it has been completely losing electrical power while driving or sitting at a light. Everything is running fine, then it just shuts off. All lights, everything. When this first started happening, the truck would start right back up.

Why does my Chevy Tahoe have no spark?

There will be a big spark when you connect the last terminal if your car would be pulling that big amps that the plastic around battery terminal starts melting. You say that there is hardly no spark if any so at the time you connect the terminals the problem is not present if the problem is not internally in the battery.

What are the symptoms of a Chevy Tahoe battery dying?

Symptoms often are that without warning it just dies and then on the next moment everything seems to be ok. Then you say the battery terminal was hot enough to melt red plastic around it. If you draw that much power from the battery then it makes a huge spark when you re-connect the cable.

Why is the POS cable on my Chevy Tahoe melting?

When I put the pos. cable back on, there is enough juice to crank it back up. There is no corrosion on the cables, but I noticed the last time this happened that the positive cable terminal was extremely hot and the stock red rubber around the cable end was starting to melt/burn.