Should I replace both ball joints at once?

If a customer needs a new ball joint, recommend replacing all of the joints at the same time. If one joint has failed, chances are the other joints may be nearing the end of their service life, too.

How to replace a lower ball joint on a Chevy 1500?

1. Remove the cotter pin and ball joint nut. 2. Using the ball joint separator and a large hammer, separate the hub assembly from the lower control arm. 3. I used a cargo strap to hold the upper control arm, rotor, and hub assembly out of the way while working on the ball joint. Step 4: The Workout!

What are the symptoms of a ball joint replacement?

What common symptoms indicate you may need to replace the Ball Joint Front? 1 Clunking noise from front tires. 2 Steering wheel shakes. 3 Car moves to the right or left, especially going over the bumps. 4 Vehicle tires have abnormal wear.

What’s the best way to replace a ball joint?

Screw in the new grease fitting and pump grease into the assembly. If you removed the brake or wheel, reattach them and lower the vehicle back down to test out the action. Bleed the brakes, if necessary. It’s a good opportunity to do any other repairs you might need to do with the brakes, since you’ve got them off.

How to replace a steering knuckle hole in a soccer ball?

Guide the new joint through the knuckle hole. Slide the new rubber boot over the ball joint’s stud and guide the new ball joint back up through the steering knuckle hole, where it came from. 2 Bolt the joint into place using the hardware included.

How do you replace ball joints?

How to Change a Ball Joint in a Car Step 1 – Lift Car Step 2 – Remove the Caliper on the Brakes Step 3 – Remove the Brake Discs Step 4 – Remove Ball Joint Nuts Step 5 – Separate Ball Joint from Hub Carrier Step 6 – Remove Ball Joint Step 7 – Grease New Ball Joint Step 8 – Add New Ball Joint In Step 9 – Take Car Down

How do you install ball joints?

Install the new ball joint in place of the old one and clip on the snap ring. Install the new castellated nut and tighten it with a socket and ratchet. Insert the cotter pin and spread it apart to lock the nut into place. Reconnect the wheel knuckle and insert the ball joint.

What are lower ball joints?

The lower ball joint is what attaches the steering knuckle and control arm together. There are two pieces which make up the lower ball joint; a socket and ball. These pieces are inside of a rubber boot that is filled with lubricant. Basically, the lower ball joint allows the wheels and tires to be connected to the vehicle and its steering assembly.

What is a ball joint?

A ball joint is a style of pivot joint that gives relative freedom of movement to a connected object. These joints typically consist of two parts, the ball and the case, but some ball joints use a connective piece that links the two parts together.