What does the code P1870 mean?
Transmission Component Slippage
Diagnostic trouble code P1870 (Transmission Component Slippage) is a General Motors-specific code whose set parameters are determined by transmission type and engine size. The PCM monitors and compares engine speed to vehicle speed after the converter clutch has been commanded ON in either high gear or Overdrive.
What does the p1870 Chevrolet engine code mean?
Start by checking the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. What does this mean? The cost to diagnose the P1870 CHEVROLET code is 1.0 hour of labor.
What is the diagnostic code for a Chevy check engine light?
Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Chevy diagnostic trouble codes. Manufacturer Specific Codes P0342Camshaft Position Sensor A Bank 1 Low Input – Related Information P1031HO2S Heater Current Monitor Control Circuit Sensors 1
How much does it cost to repair a p1870 Chevy?
An error occurred while retrieving sharing information. Please try again later. What does this mean? The cost of diagnosing the P1870 CHEVROLET code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
Start by checking the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. What does this mean? The cost to diagnose the P1870 CHEVROLET code is 1.0 hour of labor.
What does PCM code p1870 stand for?
Once the vehicle has made it to a cruise state, the PCM then begins to monitor the vehicle’s cruise ratio. If at some point the transmission begins to slip, P1870 sets and line pressure is elevated in an attempt to stop any further slippage and prevent further damage.
What is the diagnostic code for transmission slippage?
Diagnostic trouble code P1870 (Transmission Component Slippage) is a General Motors-specific code whose set parameters are determined by transmission type and engine size. The PCM monitors and compares engine speed to vehicle speed after the converter clutch has been commanded ON in either high gear or Overdrive.
What is the diagnostic code for a GM transmission?
An appreciation of how it works will help you understand why if something goes wrong. Diagnostic trouble code P1870 (Transmission Component Slippage) is a General Motors-specific code whose set parameters are determined by transmission type and engine size.