Where is the throttle actuator control located?

The Throttle Actuator Control (TAC) system uses 2 Throttle Position (TPS) sensors to monitor the throttle position. The TP sensors 1 and 2 are located within the throttle body assembly. Each sensor has the following circuits: A 5-volt reference circuit.

When to set the throttle code p2101?

Typically, when the command to the motors to move the plate does not correspond to the voltage signal sent back by the throttle position sensors (TPS), code P2101 can be set. What are the common causes of code P2101?

What are the symptoms of code p2101?

Faulty Throttle Actuator Control (TAC) module/Throttle Body (Very Common – especially if it was cleaned by someone not familiar with the correct cleaning procedure for the particular vehicle or if the TAC/ETC system relearn procedure was not carried out correctly) What are the symptoms of code P2101? How do you troubleshoot code P2101?

What does a p2101 code on a TAC mean?

If all tests have passed so far, and you continue to get a P2101 code, this would most likely indicate a failed Throttle Body Assembly, although a failed PCM could not be ruled out until the TAC/ETC system had been replaced.

When to use the p2101 code on a Honda Accord?

The P2101 code will trigger once the PCM detects that the electronic throttle actuator is not following commands. For example, when the throttle is not opening accordingly. Many owners have reported P2101 for the following makes: Honda (especially on a Honda Accord), Chevrolet, Nissan, GMC, and Chrysler.

What does p2101 mean on a throttle actuator?

P2101 is a diagnostic trouble code (DTC) for “Throttle Actuator Control Motor Circuit Range/Performance”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.

What does p2101 stand for in diagnostic code?

Diagnostic Trouble Code (DTC) P2101 stands for Throttle Actuator “A” Control Motor Circuit Range/Performance. It is usually triggered when your vehicle’s powertrain control module (PCM) detects that the actual throttle position does not match the desired throttle position.

The P2101 code will trigger once the PCM detects that the electronic throttle actuator is not following commands. For example, when the throttle is not opening accordingly. Many owners have reported P2101 for the following makes: Honda (especially on a Honda Accord), Chevrolet, Nissan, GMC, and Chrysler.

What is the diagnostic code for throttle actuator?

P2101 is a diagnostic trouble code (DTC) for “Throttle Actuator Control Motor Circuit Range/Performance”.