How do you replace power steering pump on Dodge Ram?

While squeezing the clamp, pull the line and twist the rubber line off the hard line. A screwdriver can be used to pry the line off as well. Now, using an 18mm wrench, remove the pressure line. It will be easier to access from underneath the truck.

What happens when a power steering pump fails?

Power steering pumps continuously turn as the engine is operating to keep a pressurized supply of fluid available at the steering rack. Power steering pump failures happen, and when they do, your stuck cranking the wheel with two hands until a new pump is installed. This article applies to the Dodge Ram 2nd Generation (1994-2001).

How do you change the power steering fluid?

Refer to the Related Article: How to Change Power Steering Fluid. The most common means of doing this is to use a suction device (turkey baster, syringe, or comparable) and suck fluid up from the power steering reservoir, cycling the fluid from the pump by moving the steering from lock-to-lock a few times. Then, removing the additional fluid.

Can a steering pump be replaced on a Cummins?

Replacing the steering pump on your Cummins is a simple way to maintain proper steering mechanics. Remove the fluid from the steering pump. Some model years have a drain plug in the back of the pump housing. If there is no drain plug, siphon out the fluid and dispose of it according to local laws.

When to change power steering pump in Dodge Ram 1500?

This article applies to the Dodge Ram 1500 (1994-2008). If you’re the DIY type of person who likes to keep your vehicle running like new, checking the fluid in your power steering pump reservoir is basic stuff. Changing it, if needed, is a no-brainer process that’ll pay off in the long run with the extended life of your Ram.

How do you change the power steering pump?

Insert the feed and return lines into the new pump and tighten down the compression fittings with the appropriate wrench. Fill the pump with new power steering fluid. The pump will fill the feed and return lines with fresh fluid once the engine is turned on, so start the vehicle and move the steering wheel one full turn in each direction.

How to replace power steering fluid in Dodge Ram?

By turning your wheel to either side, you pumped more old fluid into the reservoir. Use the baster to remove that fluid as well. Figure 4. Remove additional fluid that has appeared from the steering wheel turn. Pour fresh power steering fluid into the power steering reservoir until you reach the max line. Figure 5.

Power steering pumps continuously turn as the engine is operating to keep a pressurized supply of fluid available at the steering rack. Power steering pump failures happen, and when they do, your stuck cranking the wheel with two hands until a new pump is installed. This article applies to the Dodge Ram 2nd Generation (1994-2001).