What size speakers are in a 2008 Chevy Malibu?
Speakers that fit your 2008 Chevrolet Malibu*
Speaker location | Speaker sizes** |
---|---|
Front Door | 2 ohm 6-3/4″ |
Front Pillars | Tweeter |
Rear Deck Corners | 6×9″ |
Does a 2009 Chevy Malibu have a factory amp?
The 2009 Chevy Malibu’s factory amp can be installed in the rear of the trunk on the passenger side of the vehicle. The Malibu is equipped two 6-3/4 inch front door speakers and two 6 by 9 inch rear door speakers. The front pillars are installed with tweeters.
How many speakers are in a 2011 Chevy Malibu?
6
Chevy Malibu with 6-Speaker System 2011, GM Original Equipment™ Front Door Speaker by ACDelco®. Music will sound its best with ACDelco GM Original Equipment Car Speakers, and are GM-recommended replacements for your vehicle’s original… Chevy Malibu 2011, GM Original Equipment™ Rear Speaker by ACDelco®.
How to tell if a speaker is positive or negative?
1 In some cases, a black dot or a red or black stripe is used to mark the positive terminal 2 If a speaker has terminals of 2 different sizes, the larger of the 2 is normally the positive one 3 For speakers with wire already attached, typically the brass or golden-colored wire is the positive one
Which is the positive wire on a speaker wire?
You may see a copper wire instead of a green wire for the ground. Know that the copper wire is usually positive on a speaker wire. On a standard wire used for things like speakers and amps, the silver strand is the negative wire and the copper-colored strand is the positive wire.
What happens if you wire two speakers in a stereo?
If you wire 2 speakers in a stereo with different polarities (for example, one has positive and negative wired as labeled, and the 2nd speaker has the opposite) an interesting thing occurs: they’re out of phase and some sound cancels out. The result is a strange and poor sounding stereo.
What kind of wire to use on aftermarket stereo?
Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts. IMPORTANT – There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first.
Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts. IMPORTANT – There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first.
What are the colors of a car stereo?
1 Gray Left Front Speaker (-) 2 Tan Left Front Speaker (+) 3 Dark Green Right Front Speaker (-) 4 Light Green Right Front Speaker (+) 5 Black Ground
Can you swap yellow wires on a stereo?
Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts. IMPORTANT – There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness.