How much is it to replace trunk lock?

The average trunk lock actuator replacement cost in most vehicles is between $263 and $278, with the labor costs between $53 and $66, and the cost of the parts around $210.

How do I get my Cavalier out of theft mode?

Re: HOW TO BYPASS THE ANTI THEFT SYSTEM IN A CHEVY… Turn key on if u see system security light flashing wait 10 min when light turns off turn key off wait 5 sec repeat that same process 2 more times for a total of 30 min on the last one turn key to off wait 5 sec then start worked on a 2000 cavalier.

Why will my trunk not close?

Damage to the latch can prevent the trunk from closing properly. If the latch appears bent or broken, it should be replaced. Damage to the body of the car can also prevent the latch from catching. Dents around the latch, for instance, may push the latch out of alignment and prevent the trunk from closing.

How does a trunk lock work?

The trunk lock actuator is the electric motor that can be remotely triggered via the fob device or is activated by pressing a button inside the vehicle. The trunk lock actuator then releases the trunk latch so the trunk can be opened. All of this is done without you having to insert a key into the lock cylinder.

How do you change a trunk lock actuator?

Part 1 of 2: Disconnecting the old trunk lock actuator

Materials Needed.
Step 1: Access the trunk and locate the trunk lock actuator.
Step 2: Remove the plastic cover and the trunk liner.
Step 3: Remove the actuator cables and any electrical connectors.
Step 4: Remove the old actuator.

How do you break into a locked trunk?

There are a few options to consider.

Get Your Spare Keys.
Use the Trunk Release Button.
Fold Your Seats Down.
Override the Locking Mechanism.
Call a Locksmith.
Pop-A-Lock of Phoenix.

How do I get my car out of theft mode?

Method 3: Insert the key into your car’s door Step 1: Insert the key into the door lock. Use the side door on the driver’s side and the physical key even if there is a keyless entry system on the car. Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in the position.

How do you change the key on a car trunk?

Place the bit into the key slot of the lock and drill through the entire cylinder. Push up and own on the trunk lid until the lock releases and opens the trunk. Remove any interior body panels that prevent access to the trunk key lock. Use a flat-head screwdriver to pry out any clips or push snaps that hold the body panels in place.

How to install a new trunk lock cylinder?

1 Install the new lock cylinder. Feed the new lock cylinder into the hole in the trunk door, rotating as necessary to get it to seat properly. 2 Reconnect the actuator rod (s) Reinstall the actuator rod or rods into the clip on the lock cylinder. 3 Test the new mechanism. 4 Reinstall the trunk liner. …

How do you take a trunk lock out of a car?

Insert a Phillips screwdriver through the access holes to remove the four screws holding the trunk lock cylinder in place. Pull the trunk lock out of the car when all the screws are removed. Release the cylinder pin.

Where is the pin on the trunk lock?

Pull the trunk lock out of the car when all the screws are removed. Release the cylinder pin. On the side of the key lock cylinder (the round tube in the center of your lock that the key turns to activate the lock) there will be a small circular pin that is flush to the surface of the cylinder body.