How to replace a belt tensioner on a 99 Chevy Cavalier?

How to Replace a Belt Tensioner on a 99 Chevy Cavalier. 1 Step 1. Open the hood, and prop it up. Move to the front passenger side of the engine, and locate the spring-loaded belt tensioner above the 2 Step 2. 3 Step 3. 4 Step 4. 5 Step 5.

How do you hang a belt on an alternator pulley?

Turn the belt tensioner clockwise from the bolt in the middle of the tensioner pulley with a breaker bar and socket. Slip the belt off the tensioner pulley, and release the breaker bar. Hang the belt to the side of the alternator pulley with a bungee cord to prevent it from sliding out of any of the accessory pulleys.

Can you reset the anti theft system on a Cavalier?

Thanks for your advice i appreciate the help. what i did is while the car was running with the stereo on i cut the wires to the anti theft system that come from the ignition. then opened the odometer up and put electricle tape over the light. Yes, cutting the yellow wire will do it. If you disconnect the battery you need to reset it.

When to turn off ACC on Chevy Cavalier?

2ND TURN TO ACC LET IT STAY ON OF 11 MINS. TURN IT OFF AND BACK ON TO ACC FOR 11 MINS. TURN IT OFF AND BACK ON TO ACC FOR 11 MINS. THE CAR ON ALL THE WAY JUST TO THE ACC WHEN TRYING TO RESET . AFTER THE 33 MINS IT’S OK TO START.

What is the belt tensioner on a Chevy Cavalier?

The belt tensioner on the front of the 1999 Chevy Cavalier engine is a spring-loaded component that tensions the belt as it turns around all of the accessory pulleys. When the motor is running, the belt travels around the alternator pulley, crankshaft pulley, power-steering pump pulley, air-conditioner pulley and the water pump pulley.

How do you change the mounts on a Chevy Cavalier?

The mounts on a 1999 Chevrolet Cavalier can be changed by most novice mechanics with a few common tools as this is a straightforward task that can be completed in under an hour once the engine weight is removed from the two mounts. Raise the front of the vehicle with an automobile jack and secure it on jack stands. .

How do you change the tensioner on a car?

Slide the bungee cord off the belt. Turn the tensioner clockwise with the breaker bar and socket. Slip the new belt around the tensioner pulley, and release the tensioner. Pull the breaker bar out of the engine well. Crank the engine to ensure the tensioner is working properly.

Turn the belt tensioner clockwise from the bolt in the middle of the tensioner pulley with a breaker bar and socket. Slip the belt off the tensioner pulley, and release the breaker bar. Hang the belt to the side of the alternator pulley with a bungee cord to prevent it from sliding out of any of the accessory pulleys.

Where is the belt tensioner on a Chevy Cavalier?

Open the hood on the 1998 Chevy Cavalier and locate the spring loaded belt tensioner. It’s on the front passenger side of the engine or in the front center of the engine. Use the bolt head in the middle of the tensioner pulley to loosen the tension off of the belt.

How do you remove a belt from a belt tensioner?

Remove the belt from the belt tensioner. Turn the belt tensioner clockwise from the bolt in the middle of the tensioner pulley with a breaker bar and socket. Slip the belt off the tensioner pulley, and release the breaker bar.