Where is the spark plug on Mallory Unilite distributor?

Disconnect the trigger wire from the coil (-) terminal. Locate the spark plug wire on the original distributor cap that that is used to set engine timing. See a service manual for this location. Mark the distributor cap and distributor housing at this spark plug wire position. Step 2

Where can I find a firing order diagram for a Pontiac 8?

Find solutions to your pontiac 8 firing order question. Get free Pontiac-built , , , , V8 Engine Firing Order: Firebird firing order diagram. I need the diagram for a distributor cap and plugs. or firing engine order for a pontiac Pontiac V8. , , *, , , , , , , At this site you can find the firing orders for Chevrolet engines.

How to install a distributor and set initial timing?

Leave a little extra room with the spark plug wires to allow freedom of movement in the distributor. For Chevys, be careful to make sure 5 and 7 are installed correctly. If the wires are accidentally switched, the engine will not be happy. Before we try to start the engine, be sure the distributor is connected to switched power.

How to disconnect a Mallory Distributor from a coil?

1. Disconnect the distributor from the coil (-) terminal, taking it out of the loop and allowing the test to be done properly. 2. Disconnect the wires coming from the CD box (if so equipped) connected to the coil (+ and -) terminals and connect the ignition switch 12 volts wire to the coil (+) terminal of the coil. 3.

How do you rotate a Mallory Unilite distributor?

Connect a timing light and start the engine. If the engine fails to start, rotate the distributor in small increments clockwise or counterclockwise until the engine starts. Do not exceed more than ten degrees of distributor housing rotation in either direction. Step 3

What is the firing order of a Pontiac V8?

Pontiac V8. , , *, , , , , , , Firing Order. Cylinder Numbering, Distributor Rotation.Like all PONTIAC engines since , the firing order sets is: , all by turning it counterclockwise. Note that the cylinder number 1 is the next driver in front of the engine (the same location on all V-engines) or just the first behind the power steering pump.

What kind of ignition coil does Mallory Unilite use?

Ignition Coils: The UNILITE®Ignition system works with most stock ignition coils and aftermarket high performance ignition coils. For optimum performance, use a Mallory PROMASTER®Coil Part No 29440 or 29625, or Mallory Chrome Electronic Ignition Coil Part No. 29216. Spark Plug Wires:

How to troubleshoot a Mallory Point style distributor?

Mallory Distributors Manual Standard And Vacuum Advance Single And Dual Point TROUBLESHOOTING GUIDE FOR A POINT STYLE DISTRIBUTOR The following are some basic steps to take when troubleshooting a Point Style Distributor.