Why does my amp have no power?
If the remote turn-on wire doesn’t have power, your amp won’t turn on. If the remote and power wires both check out okay, the next thing to look for is continuity on the ground wire. If the ground connection is poor, or it isn’t connected at all, the amp may fail to turn on or not work very well.
Why did my amp go into protect mode?
Some amps go into protect mode if they get too hot, which can prevent a permanent failure. The common cause of overheating is a lack of airflow. If the amp is located underneath the seats, or in another confined space, that may cause it to overheat.
Where does the blue wire on a power amplifier go?
BLUE wire – connects to the REM line of a Switchable product such as Power Amplifier or the Power Antenna, as applicable. Because it has a +12DVC output when the radio is on, it is best to cap it or tape it Please confirm the Red & Yellow wires are connected.
Why does my amp not turn on when I Turn on the radio?
So if there is no power at the remote terminal on your amplifier, the next step is to check for power at the corresponding wire where it connects to the radio. If your amp is wired incorrectly, and the remote turn-on is connected instead to the power antenna wire on the head unit, you may find that the amp only powers on sometimes.
What does blue cat’s free AMP plug-in do?
Blue Cat’s Free Amp is a completely free guitar amp simulation plug-in offering three amp models created with the acclaimed Blue Cat’s Destructor amp simulation modeler. Typical applications: Guitar amp modeling for clean, crunch or heavy distortion tones.
What should I do if my amp is plugged into the wall?
If your amp plugs into the wall, test the power cord. Also, make sure your guitar, speakers, subwoofers, and other devices are connected to the amp if you’re using them.
BLUE wire – connects to the REM line of a Switchable product such as Power Amplifier or the Power Antenna, as applicable. Because it has a +12DVC output when the radio is on, it is best to cap it or tape it Please confirm the Red & Yellow wires are connected.
So if there is no power at the remote terminal on your amplifier, the next step is to check for power at the corresponding wire where it connects to the radio. If your amp is wired incorrectly, and the remote turn-on is connected instead to the power antenna wire on the head unit, you may find that the amp only powers on sometimes.
Why does my amp keep getting too much power?
Notice any broken wires, burnt-out wires, or anything else that looks out of place. These signs of damage could be the reason the amp is getting too much power. Any wires that look loose or improperly placed could also be responsible for the problem. Broken wires can easily prevent an amp from turning on.
What happens when an amp goes into Protect Mode?
Should you find that the amp has good power and ground, that the remote wire has voltage when the head unit is turned on, and that none of the fuses are blown, then you’re probably dealing with a busted amplifier. Amplifiers are often designed to go into “ protect mode ” to avoid further damage to internal components.