Are there rear disc brakes on a Pontiac Trans Am?
The rear disc brake option (J65 RPO) could also be ordered to replace the rear drum brakes. In addition, a WS7 Performance Package was offered in 1979. The WS7 package was essentially the WS6 package without the rear disc brakes. In the following procedure, you see the installation of a Macho Trans Am kit.
What should I do with my Trans Am brake caliper?
It may be necessary to have a drain pan underneath or at least a shop rag to catch the residual fluid. The brake caliper should pivot and lift off the mounting bracket. If it’s stubborn, wiggle the caliper off with a rocking motion.
How do you change the brake pads on a truck?
With your car or truck safely supported on jack stands, remove the rear wheels. Loosen the bolts that hold the brake caliper on, but don’t remove them completely yet. You should have something handy to hang the brake caliper out of the way.
How do you remove the brake line on a Pontiac Firebird?
Use a 3/8-inch Allen socket to break the torque on the caliper retainer bolts. Use a 7/16-inch open-end wrench to remove the steel brake line on each end of the axle where it attaches to the caliper flex hose.
The rear disc brake option (J65 RPO) could also be ordered to replace the rear drum brakes. In addition, a WS7 Performance Package was offered in 1979. The WS7 package was essentially the WS6 package without the rear disc brakes. In the following procedure, you see the installation of a Macho Trans Am kit.
It may be necessary to have a drain pan underneath or at least a shop rag to catch the residual fluid. The brake caliper should pivot and lift off the mounting bracket. If it’s stubborn, wiggle the caliper off with a rocking motion.
How to install a new brake on a Pontiac Firebird?
Install a new cotter pin and bend the ends around the nut. Place the dust cap square on the spindle bore and use a hammer to lightly tap it around the circumference until the cap sits flush against the rotor. Install a brake caliper rubber hose line and retainer spring clip. Install the caliper. Line up the caliper with the bracket.
Where is the retainer ring on a Pontiac Firebird?
Use a 3/8-inch line wrench to remove the short section of rubber brake line from the steel brake line at the bracket. A retainer ring is located at the back side of the brake line bracket. Use a flat-head screwdriver or pick to snag it and lift it out. A dust cap is at the center of the brake rotor.